In response to environmental concerns, researchers explore fly ash as a cement replacement material, and crushed bricks as a cost-effective and load-reducing aggregate, particularly where stone chips are scarce. Therefore, this study investigates the mechanical properties and microstructure of brick aggregate concrete (BAC) with raw fly ash (FA) as a partial replacement of cement. The research involved casting raw FA based BAC (FBAC) cylinders (100 mm diameter and 200 mm height) and prism (100 × 100 × 500 mm) with varying levels of FA (0-25%) using a constant mix proportion by volume of 1:1.5:3 (cement : fine aggregate : coarse aggregate) with a water to binder (w/b) ratio of 0.50 and three curing ages (7, 28, and 90 days). Tests for mechanical properties, including compressive strength, split tensile strength, flexural strength, modulus of elasticity, and Poisson's ratio were conducted to assess the behavior of FBAC, and microstructure were then investigated at 28 days. The results indicated that increasing the FA content up to 15% led to gradual improvement in compressive strength and tensile strength values. At 28 days, the highest values of compressive strength and split tensile strength were observed at 10% FA, with 7.9% and 14.2% increase, respectively, compared to the control concrete. However, the flexural strength of FBAC decreased gradually with cement replacement. On the other hand, modulus of elasticity and Poisson's ratio increased gradually up to 20% and 25% cement replacement, respectively. Up to 15% FA enhanced a more uniform and compact microstructure than that of control concrete. Several equations have been developed to express relationship between compressive strength and other mechanical properties of FBAC. Hence, up to 15% raw FA as a partial replacement of cement improved the mechanical properties and microstructure of BAC.
Keywords: Brick aggregate concrete; Mechanical properties; Microstructure; Raw fly ash.
© 2024 The Authors.