A fully integrated 24-GHz radar transceiver with one transmitter (TX) and two receivers (RXs) for compact frequency modulated continuous wave (FMCW) radar applications is here presented. The FMCW synthesizer was realized using a fractional-N phase-locked loop (PLL) and programmable chirp generator, which are completely integrated in the proposed transceiver. The measured output phase noise of the synthesizer is -80 dBc/Hz at 100 kHz offset. The TX consists of a three-bit bridged t-type attenuator for gain control, a two-stage drive amplifier (DA) and a one-stage power amplifier (PA). The TX chain provides an output power of 13 dBm while achieving <0.5 dB output power variation within the range of 24 to 24.25 GHz. The RX with a direct conversion I-Q structure is composed of a two-stage low noise amplifier (LNA), I-Q generator, mixer, transimpedance amplifier (TIA), a two-stage biquad band pass filter (BPF), and a differential-to-single (DTS) amplifier. The TIA and the BPF employ a DC offset cancellation (DCOC) circuit to suppress the strong reflection signal and TX-RX leakage. The RX chain exhibits an overall gain of 100 dB. The proposed radar transceiver is fabricated using a 65 nm CMOS technology. The transceiver consumes 220 mW from a 1 V supply voltage and has 4.84 mm2 die size including all pads. The prototype FMCW radar is realized with the proposed transceiver and Yagi antenna to verify the radar functionality, such as the distance and angle of targets.
Keywords: CMOS; FMCW radar; FMCW synthesizer; sensor; transceiver.