Sildenafil citrate, an oral drug used to treat erectile dysfunction, has low water solubility and oral bioavailability. The solubility is greatly influenced by the pH, changing from 37.25 mg/mL to 0.22 mg/mL with a change in pH from 1.2 to 8.0. This indicates that the absorption may decrease in patients who use drugs, such as proton pump inhibitors (PPIs), for gastroesophageal reflux disease. To improve the absorption of sildenafil citrate at various gastric pH levels, a sildenafil citrate orally disintegrating tablet (ODT), which has a rapid disintegration feature, was produced by a 3D printing technique. Our study investigated the pharmacokinetic parameters of the sildenafil citrate ODT in rats after oral administration and compared the absorption of the sildenafil citrate ODT and sildenafil citrate commercial tablet (RLD), with and without PPI treatment. The LC/MS/MS analysis of the plasma sildenafil concentration revealed that the area under curve from time 0 to infinity (AUC0-∞) of sildenafil in the sildenafil citrate ODT group was significantly higher than in the sildenafil citrate RLD group whether it was in combination with the PPI or not (274.8% and 144%, respectively; p < 0.05). The relative systemic bioavailability of sildenafil citrate RLD significantly decreased with the PPI, but that of sildenafil citrate ODT was not affected by the PPI. These results indicate that the relative systemic bioavailability of sildenafil citrate ODT was increased when it was prepared using the 3D printing technique and the absorption of this formulation was not affected by the PPI.
Keywords: 3D printing technique; bioavailability; orally disintegrating tablets; pharmacokinetics.