Effect of Food Viscosity on Drug Dissolution

Abstract

Purpose: The purpose of the present study was to investigate the effect of food viscosity on the dissolution rate of a drug. There are two types of viscosity, macroviscosity and microviscosity. Macroviscosity affects the diffusion layer thickness, whereas microviscosity affects the molecular diffusion coefficient. The mass transfer coefficient (k_c) in the intrinsic dissolution rate (IDR) depends on the viscosity (η) as k_c ∝ η^a (a is an exponent on η). In theory, for rotating flow over a disk, if a thickener increases only macroviscosity, a = -1/6, and if it increases both macroviscosity and microviscosity equally, a = -7/6.

Method: Benzocaine was used as a model drug. Hydroxypropyl cellulose (HPC) and methylcellulose (MC) were employed as control thickeners that increase only macroviscosity. Sucrose was employed as a control thickener for both macroviscosity and microviscosity. The FDA breakfast homogenate (BFH) was diluted with distilled water or 1 mM HCl with/without pepsin digestion. The IDR value was measured by the paddle-over-disk method.

Results: The η value of 30% BFH distilled water was 209 mPa∙s, about 300 times higher than distilled water. It was further increased by HCl (430 mPa∙s), and reduced by pepsin digestion (35 mPa∙s). The k_c value was little affected by BFH (a = 0.00 to -0.09), slightly less than those in HPC (a = -0.19) and MC (a = -0.21). Sucrose decreased the k_c value more significantly (a = -0.70).

Conclusion: The IDR and k_c values of benzocaine were little affected by BFH, suggesting that BFH increased only macroviscosity.

Keywords: bioavailability; bioequivalence; dissolution; food; viscosity.