Within-host Mycobacterium tuberculosis (Mtb) diversity may detect antibiotic resistance or predict tuberculosis treatment failure and is best captured through sequencing directly from sputum. Here, we compared three sample pre-processing steps for DNA decontamination and studied the yield of a new target enrichment protocol for optimal whole-genome sequencing (WGS) from direct patient samples. Mtb-positive NALC-NaOH-treated patient sputum sediments were pooled, and heat inactivated, split in replicates, and treated by either a wash, DNase I, or benzonase digestion. Levels of contaminating host DNA and target Mtb DNA were assessed by quantitative PCR (qPCR), followed by WGS with and without custom dsDNA target enrichment. The pre-treatment sample has a high host-to-target ratio of DNA (6,168 ± 1,638 host copies/ng to 212.3 ± 59.4 Mtb copies/ng) that significantly decreased with all three treatments. Benzonase treatment resulted in the highest enrichment of Mtb DNA at 100-fold compared with control (3,422 ± 2,162 host copies/ng to 11,721 ± 7,096 Mtb copies/ng). The custom dsDNA probe panel successfully enriched libraries from as little as 0.45 pg of Mtb DNA (100 genome copies). Applied to direct sputum the dsDNA target enrichment panel increased the percent of sequencing reads mapping to the Mtb target for all three pre-processing methods. Comparing the results of the benzonase sample sequenced both with and without enrichment, the percent of sequencing reads mapping to the Mtb increased to 90.95% from 1.18%. We demonstrate a low limit of detection for a new custom dsDNA Mtb target enrichment panel that has a favorable cost profile. The results also demonstrate that pre-processing to remove contaminating extracellular DNA prior to cell lysis and DNA extraction improves the host-to-Mtb DNA ratio but is not adequate to support average coverage WGS without target capture.
Keywords: direct sputum sequencing; enrichment; mycobacteria; target capture.