Displacement measurement is of great significance to monitor the crack variation and ensure the health of building structures. Aiming at the problems of low sensitivity and high temperature error of fiber Bragg grating (FBG) displacement sensors in displacement monitoring, this paper presents an adjustable cantilever beam displacement sensor with the FBGs as the sensing element. The sensor adds double FBGs on the relative surfaces of the equal-strength cantilever beam, which increases the bending deformation on the FBG of the beam surface to improve the sensitivity and realize the temperature compensation of the sensor. By adding an adjustable external rod structure between a flexible spring and a fixed foot stand, the sensor can regulate the range of initial crack width for different occasions. A theoretical analysis of the displacement sensor is performed, and the simulation analysis and optimization design for the structural parameters of the cantilever beam elastic sensitive element are implemented by adopting SolidWorks and ANSYS software. Finally, a displacement testing platform is constructed to test its performance. Experimental results show that this design has a high sensitivity coefficient of 39.47 pm/mm and a temperature coefficient of 1.04 pm/°C in the range of initial crack width from 0 to 110 mm or from 0 to 130 mm depending on different monitoring situations. Furthermore, good linearity, hysteresis delay, repeatability, and temperature compensation performance have also been demonstrated.
© 2023 Author(s). All article content, except where otherwise noted, is licensed under a Creative Commons Attribution (CC BY) license (http://creativecommons.org/licenses/by/4.0/).