Benzophenone: A Small Molecule Additive for Enhanced Performance and Stability of Inverted Perovskite Solar Cells

Hytham Elbohy; Hiroo Suzuki; Takeshi Nishikawa; Thiri Htun; Kosei Tsutsumi; Chiyu Nakano; Aung Ko Ko Kyaw; Yasuhiko Hayashi

doi:10.1021/acsami.3c09835

Benzophenone: A Small Molecule Additive for Enhanced Performance and Stability of Inverted Perovskite Solar Cells

ACS Appl Mater Interfaces. 2023 Sep 27;15(38):45177-45189. doi: 10.1021/acsami.3c09835. Epub 2023 Sep 12.

Authors

Hytham Elbohy^{1

2}, Hiroo Suzuki¹, Takeshi Nishikawa¹, Thiri Htun¹, Kosei Tsutsumi¹, Chiyu Nakano¹, Aung Ko Ko Kyaw³, Yasuhiko Hayashi¹

Affiliations

¹ Graduate School of Natural Science and Technology, Okayama University, Okayama 700-8530, Japan.
² Physics Department, Faculty of Science, Damietta University, New Damietta 34517, Egypt.
³ Guangdong University Key Laboratory for Advanced Quantum Dot Displays and Lighting and Department of Electrical & Electronic Engineering, Southern University of Science and Technology, Shenzhen 518055, P. R. China.

PMID: 37699120
DOI: 10.1021/acsami.3c09835

Abstract

In this study, we investigated the impact of benzophenone (BP), a small molecule additive, on the performance and stability of inverted perovskite solar cells (PSCs). Specifically, we introduced BP into the perovskite precursor solution of FAPbI₃ to fabricate PSCs with an ITO/PEDOT:PSS/BP:FAPbI₃/PCBM/C₆₀/PCB/Ag architecture. The incorporation of BP with an optimum concentration of 2 mg mL^-1 significantly enhanced the power conversion efficiency (PCE) of the inverted PSC from 13.12 to 18.84% with negligible hysteresis. Notably, the BP-based PSCs retained ∼90% of their initial PCE after being stored in ambient air with 30% relative humidity at 25 °C for 700 h. In contrast, control devices showed rapid degradation, retaining only 30% of their initial value within 300 h under the same conditions. We attributed the superior performance and stability of the BP-based PSCs to the grain boundary passivation of the perovskite film. The improvement was mainly attributed to the intermolecular interaction between the O-donor Lewis base BP material and both Pb²⁺ and FA⁺ in FAPbI₃. This effectively suppresses trap-assisted recombination and promotes the conversion of the δ-phase to photoactive and stable α-phase FAPbI₃. Overall, our findings suggest that BP is a promising additive for improving the performance and stability of inverted PSCs.

Keywords: additive; air stability; benzophenone; defects passivation; perovskite solar cell.