3D-printed electrochemical cells with laser engraving: developing portable electroanalytical devices for forensic applications

Tiago A Matias; David L O Ramos; Lucas V Faria; Abner de Siervo; Eduardo M Richter; Rodrigo A A Muñoz

doi:10.1007/s00604-023-05872-2

3D-printed electrochemical cells with laser engraving: developing portable electroanalytical devices for forensic applications

Mikrochim Acta. 2023 Jul 18;190(8):297. doi: 10.1007/s00604-023-05872-2.

Authors

Tiago A Matias¹, David L O Ramos², Lucas V Faria², Abner de Siervo³, Eduardo M Richter², Rodrigo A A Muñoz⁴

Affiliations

¹ Center for Research on Electroanalysis, Institute of Chemistry, Federal University of Uberlândia, Uberlândia, MG, 38408-100, Brazil. tiagomatias.edu@gmail.com.
² Center for Research on Electroanalysis, Institute of Chemistry, Federal University of Uberlândia, Uberlândia, MG, 38408-100, Brazil.
³ Institute of Physics Gleb Wataghin, Applied Physics Department, State University of Campinas, Campinas, SP, 13083-859, Brazil.
⁴ Center for Research on Electroanalysis, Institute of Chemistry, Federal University of Uberlândia, Uberlândia, MG, 38408-100, Brazil. munoz@ufu.br.

PMID: 37460848
DOI: 10.1007/s00604-023-05872-2

Abstract

A new electrochemical device fabricated by the combination of 3D printing manufacturing and laser-generated graphene sensors is presented. Cell and electrodes were 3D printed by the fused deposition modeling (FDM) technique employing acrylonitrile butadiene styrene filament (insulating material that composes the cell) and conductive filament (lab-made filament based on graphite dispersed into polylactic acid matrix) to obtain reference and auxiliary electrodes. Infrared-laser engraved graphene, also reported as laser-induced graphene (LIG), was produced by laser conversion of a polyimide substrate, which was assembled in the 3D-printed electrochemical cell that enables the analysis of low volumes (50-2000 μL). XPS analysis revealed the formation of nitrogen-doped graphene multilayers that resulted in excellent electrochemical sensing properties toward the detection of atropine (ATR), a substance that was found in beverages to facilitate sexual assault and other criminal acts. Linear range between 5 and 35 μmol L^-1, detection limit of 1 μmol L^-1, and adequate precision (RSD = 4.7%, n = 10) were achieved using differential-pulse voltammetry. The method was successfully applied to beverage samples with recovery values ranging from 80 to 105%. Interference studies in the presence of species commonly found in beverages confirmed satisfactory selectivity for ATR sensing. The devices proposed are useful portable analytical tools for on-site applications in the forensic scenario.

Keywords: 3D-printing; Conductive filament; Differential-pulse voltammetry; Electrochemical sensors; Forensic; Laser-induced graphene; On-site analysis.