Investigations on the structural variations in the cribriform plate (CP), olfactory foramina and the Crista Galli showcase the benefits of using 3D imaging on smaller structures. These techniques reveal accurate details about bone morphology and density. Comparing different techniques, this project aims to examine the correlation between the CP, olfactory foramina, and Crista Galli. Computed tomography was used to translate and apply the findings acquired from the samples in radiographic studies on CPs for potential clinical significance. The findings show that the surface area measurements were significantly larger when using 3D imaging techniques in comparison with the 2D counterpart. Using 2D imaging, the maximum surface area of the CPs was 239.54 mm2, however, paired 3D samples showed the maximum surface area was 355.51 mm2. The findings show that Crista Galli's dimensions varied greatly, with length ranging from 15 to 26 mm, height ranging from 5 to 18 mm, and width ranging from 2 to 7 mm. The 3D imaging allowed for surface area measurements on the Crista Galli, and the surface area ranged from 130 to 390 mm2. When 3D imaging was used, significant correlations were found between the surface area of the CP and the length of the Crista Galli (p = 0.001). The findings show that measurements on the Crista Galli using 2D and 3D reconstructed radiographic imaging reflect similar ranges of dimensions to 3D imaging measurements. The findings also suggest that the Crista Galli may increase in length with the CP to support the latter and olfactory bulb during trauma which may be used by clinicians alongside 2D CT scans for optimal diagnosis.
Keywords: 2D imaging; 3D imaging; Computed tomography; Cribriform plate; Crista Galli.
© 2023. The Author(s).