The fabrication of a cost-efficient cathode is critical for in-situ electrochemical generation of hydrogen peroxide (H2O2) to remove persistent organic pollutants from groundwater. Herein, we tested a stainless-steel (SS) mesh wrapped banana-peel derived biochar (BB) cathode for in-situ H2O2 electrogeneration to degrade bromophenol blue (BPB) and Congo red (CR) dyes. Furthermore, polarity reversal is evaluated for the activation of BB surface via introduction of various oxygen containing functionalities that serve as active sites for the oxygen reduction reaction (ORR) to generate H2O2. Various parameters including the BB mass, current, as well as the solution pH have been optimized to evaluate the cathode performance for efficient H2O2 generation. The results reveal formation of up to 9.4 mg/L H2O2 using 2.0 g BB and 100 mA current in neutral pH with no external oxygen supply with a manganese doped tin oxide deposited nickel foam (Mn-SnO2@NF) anode to facilitate the oxygen evolution reaction (OER). This iron-free electrofenton (EF) like process enabled by the SSBB cathode facilitates efficient degradation of BPB and CR dyes with 87.44 and 83.63% removal efficiency, respectively after 60 min. A prolonged stability test over 10 cycles demonstrates the effectiveness of polarity reversal toward continued removal efficiency as an added advantage. Moreover, Mn-SnO2@NF anode used for the OER was also replaced with stainless steel (SS) mesh anode to investigate the effect of oxygen evolution on H2O2 generation. Although Mn-SnO2@NF anode exhibits better oxygen evolution potential with reduced Tafel slope, SS mesh anode is discussed to be more cost-efficient for further studies.
Keywords: Banana-peel; Biochar; H2O2 synthesis; Oxygen reduction reaction; Water remediation.