Purpose: Intraoperative radiographs and fluoroscopy are used in adult spinal deformity (ASD) surgery to prevent postoperative coronal malalignment but with limited accuracy. Therefore, we applied a computer-assisted rod bending system (CARBS: Bendini®) for an intraoperative coronal alignment evaluation. The purpose of this study is to introduce this novel technique and validate its accuracy.
Methods: Fifteen ASD patients were included in the study. The heads of the bilateral S1 pedicle screws (S1), the S1 spinous process, and the bilateral greater trochanter (GT) and the C7 spinous process were recorded with CARBS for an intraoperative coronal alignment evaluation. The lines which connect the bilateral S1 and GT were used as references. The C7-center sacral vertical line (C7-CSVL) on the CARBS monitor was checked, and the C7-CSVL from the intraoperative CARBS recording and postoperative standing whole spine radiograph were compared.
Results: Intraoperative C7-CSVL with CARBS was 35.1 ± 31.6 mm when the S1 pedicle screws were used as the reference line and was 16.6 ± 17.8 mm when the GTs were used. Postoperative C7-CSVL by radiograph was 15.1 ± 16.5 mm. In addition, the intraoperative C7-CSVL with CARBS and the postoperative C7-CSVL showed a strong positive correlation in both GT (R = 0.86, p < 0.01) and in S1(R = 0.79, p < 0.01), with a better correlation found in GT than in S1.
Conclusion: Intraoperative C7-CSVL with CARBS was found to be highly accurate in ASD surgery. Our results suggest that this novel technique can be useful as an alternative to intraoperative radiography and fluoroscopy and may reduce radiation exposure.
Keywords: Adult spinal deformity (ASD); C7-center sacral vertical line (C7-CSVL); Computer-assisted rod bending system (CARBS); Coronal malalignment (CM); Navigation system, intraoperative coronal alignment.
© 2023. The Author(s), under exclusive licence to Scoliosis Research Society.