Wear of the secondary of the welding gun, caused by mechanical fatigue or due to a bad parameterization of the welding points, causes an increase in quality problems such as non-existent welds or a reduced weld nugget size. In addition to quality problems, this defect causes production stoppages that affect the final cost of the manufactured part. Different studies have focused on evaluating the importance of different welding parameters, such as current, in the final quality of the welding nugget. However, few studies have focused on preventing weld command parameters from degrading or changing. This investigation seeks to determine the wear of the secondary circuit to avoid variability in the current supplied to the welding point caused by this defect and the increase in circuit resistance, especially in industrial environments. In this work, a virtual sensor is developed to estimate the resistance of the welding arm based on previous research, which has shown the possibility of detecting secondary wear by analysing the duty cycle of the power circuit. From the data of the virtual sensor, an anomaly detection method based on the Mahalanobis distance is developed. Finally, an integral system for detecting secondary wear of welding guns in real production lines is presented. This system establishes performance thresholds based on the analysis of the Mahalanobis distance distribution, allowing monitoring of the secondary circuit wear condition after each welding cycle. The results obtained show how the system can detect incipient wear in welding guns, regardless of which part of the secondary the wear occurs, improving decision-making and reducing quality problems.
Keywords: MFDC welding; Mahalanobis distance; virtual sensor; wear monitoring.