Objective: to evaluate the bond strength of repairs to composite resin restorations treated with CO2 laser and bifunctional monomers after 1 year of aging. Background: Adequate bond strength between a composite restoration and resin repair agent can be achieved through mechanical and/or chemical treatment. However, the longevity of such repairs is unknown. Methods: Resin blocks (volume: 125 mm3) were created. Failure surfaces were either not treated or were treated before the repair with a universal adhesive, a silane bonding agent and/or CO2 laser. The blocks were distributed into six groups (n = 6 per group): resin+resin group (RRG), universal adhesive+resin group (ARG), silane+universal adhesive group (SAG), laser+silane+universal adhesive group (LSAG), laser+universal adhesive group (LAG), and laser+silane group (LSG). After treatment, repairs were made with another resin composite. "Sticks" (1.0 mm2 in area and 1.0 cm in length) were cut from the specimens in each group and immersed in distilled water at 37°C. Microtensile bond strength was evaluated after 1 year of aging. Bond strength values were compared using the Kruskal-Wallis test and Dunn's test. Results: Bond strength was significantly higher in the LSAG compared with the RRG, adhesive system, LSG, whereas statistically similar results were found for the SAG, LSAG, and LAG. Bond strength was lowest in the RRG. The LSAG and LAG presented predominantly cohesive fractures. Conclusions: The bond strength of composite resin repairs was satisfactory over time. Treatment with CO2 laser contributed to the maintenance of bond strength during the 1-year storage period and bifunctional monomers present in the universal adhesive on the irradiated repair surface were of fundamental importance to the maintenance of bond strength values, as demonstrated by microtensile bond test and fracture pattern analysis.
Keywords: CO2 laser; resin composite; resin repairs; silane; universal adhesive.