Compared with polymers and nanoparticles, fatty alcohols can not only increase the stability of foam, but also maintain better foamability at pH < 2, which is beneficial to reduce waste liquid and increase decontamination efficiency for radioactive surface pollution. However, different fatty alcohols have different hydrophobic chain lengths. The effects of fatty alcohols with different chain lengths on the performance of decontamination foam were studied at pH < 2, to assist in the selection of suitable fatty alcohols as foam stabilizers. Combined with betaine surfactant and phytic acid, biomass-based foams were synthesized using fatty alcohols with different chain lengths. When the hydrophobic tail groups of the fatty alcohol and the surfactant were the same, the foam showed the best performance, including the lowest surface tension, the highest liquid film strength, the greatest sag-resistance and the best stability. However, when the hydrophobic tail groups were different, the space between adjacent surface active molecules was increased by thermal motion of the excess terminal tail segments (a tail-wagging effect), and the adsorption density reduced on the gas-liquid interface, leading to increased surface tension and decreased liquid film strength, sag-resistance and stability. The use of decontamination foam stabilized by fatty alcohols with the same hydrophobic group as the surfactant was found to increase the decontamination rate of radioactive uranium pollution from 64 to over 90% on a vertical surface.
Keywords: biomass-based; chain-length matching; foam decontamination; low pH; radioactive pollution.