In this work, we developed and optimized a method for the analysis of PAHs and nitro-PAHs in atmospheric particulate matter (PM) samples by using thermal desorption gas chromatography coupled with electron ionization single quadrupole mass spectrometry (TD-GC-(EI)-MS). The method uses thermal desorption from a PM on a filter sample as means of sample introduction to a column and obviates the need for complex extraction procedures, which are time-consuming and require environmentally unfriendly solvents. Moreover, the possibility of systematic errors is minimized and a significantly smaller amount of sample is required compared to traditional techniques requiring a pre-extraction step (approx. 10-times). Thirteen PAHs and three nitro-PAHs were used during method development. Although Tenax cartridges are typically used to capture volatile pollutants from the air, we found that glass-wool liner is the most suitable trap for the examined analytes after desorption from a quartz filter. Among the various instrument parameters which were tested and optimized, TD desorption flow and hold time, and temperature of the cooled injection system (CIS) proved to be most critical. We also found out that the matrix effect is especially pronounced in the case of high PM loadings, which should be kept in mind when planning the analysis. After the optimization, standard reference materials (ERM-CZ100 and NIST 1648a) were used for partial method validation and finally, real PM10 and PM2.5 samples from two Slovenian cities were successfully analyzed.
Keywords: Air pollution monitoring; Green analytical method; Nitrated polycyclic aromatic hydrocarbons; Particulate matter; TD-GC-MS.
Copyright © 2022 Elsevier B.V. All rights reserved.