Currently, the influence of geogrid mesh size on interface characteristics are disregarded in various codes and standards. To explore the reasonable mesh size of geogrid used for reinforced tailings, the direct shear test and pull-out test of geogrid reinforced tailings with different mesh sizes were done. The results show that the shear surface of geogrid reinforced tailings is characterized by the combined action of geogrid-tailings interface and tailings-tailings interface; the geogrid-tailings interface friction was separated from the comprehensive interface friction to analyze the influence of area ratio on it under different test conditions; and the mesh size of geogrid reinforced tailings, that is, the area ratio of the geogrid-tailings interface to the shear surface (α), has a greater influence on the pseudo-cohesion and less on the pseudo-friction angle. The friction strength of the geogrid-tailings interface increases slightly with increasing mesh size, then decreases sharply, and the reinforcement effect of geogrid quickly disappears. Considering the direct shear test and pull-out test, the reasonable mesh size of geogrid reinforced tailings should be the mesh size corresponding to α 0.47-0.55. With the increase α, the effect of the geogrid reinforced tailings can be divided into four stages where the third stage ([Formula: see text]) is the stage with the best reinforcement effect.
© 2022. The Author(s).