Polymers of micro(nano) plastic in household tap water of the Barcelona Metropolitan Area

Water Res. 2022 Jul 15:220:118645. doi: 10.1016/j.watres.2022.118645. Epub 2022 May 22.

Abstract

Microplastics (MPLs) are emerging persistent pollutants affecting drinking water systems, and different studies have reported their presence in tap water. However, most of the work has a focus on particles in the 100-5 µm range. Here, a workflow to identify and quantify polymers of micro and nanoplastics (MNPLs), with sizes from 0.7 to 20 µm in tap water, is presented. The analytical method consisted of water fractionated filtration followed by toluene ultrasonic-assisted extraction and size-exclusion chromatography, using an advanced polymer chromatography column coupled to high-resolution mass spectrometry with atmospheric pressure photoionization source with negative and positive ionization conditions (HPLC(APC)-APPI(±)-HRMS) and normal phase chromatography HILIC LUNA® column and electrospray ionisation source in positive and negative mode (HPLC(HILIC)-ESI(±)-HRMS). The acquisition was performed in full scan mode, and the subsequent tentative identification of MNPLs polymers has been based on increasing the confirmation level, including the characterisation of monomers by using Kendrick Mass Defect (KMD) analysis, and confirmation and quantification using standards. This approach was applied to assess MNPLs in tap water samples of the Barcelona Metropolitan Area (BMA), that were collected from August to October 2020 from home taps of volunteers distributed in the 42 postal codes of the BMA. Polyethylene (PE), polypropylene (PP), polyisoprene (PI), polybutadiene (PBD), polystyrene (PS), polyamide (PA), and polydimethylsiloxanes (PDMS) were identified. PE, PP, and PA were the most highly detected polymers, and PI and PBD were found at the highest concentrations (9,143 and 1,897 ng/L, respectively). A principal component analysis (PCA) was conducted to assess differences in MNPLs occurrence in drinking water, that was provided from the two drinking water treatment plants (DWTPs) suppliers. Results showed that no significant differences (at 95% confidence level) were established between the drinking water supplies to the different areas of the BMA.

Keywords: Barcelona; HPLC-HRMS; Microplastics; Nanoplastics; Suspect screening.

MeSH terms

  • Chromatography, High Pressure Liquid
  • Drinking Water* / analysis
  • Humans
  • Plastics / analysis
  • Polyethylene / analysis
  • Polymers / analysis
  • Water Pollutants, Chemical* / analysis

Substances

  • Drinking Water
  • Plastics
  • Polymers
  • Water Pollutants, Chemical
  • Polyethylene