Influence of Freeze-Thaw Cycles on the Mechanical Properties of Highly Rubberised Asphalt Mixtures Made with Warm and Cold Asphalt Binders

Materials (Basel). 2022 Apr 6;15(7):2701. doi: 10.3390/ma15072701.

Abstract

The present study has been developed to investigate the effect of freeze and thaw (F-T) cycles on the characteristics of highly rubberised asphalt materials to be used as impact-absorbing pavement (IAP) in urban road infrastructures. The tested samples were produced in the laboratory following the dry process incorporation. Two main types of crumb rubber particles in the range of 0-4 mm were used. Moreover, two types of binders, one warm and one cold, were utilised to prove the feasibility of cold-produced admixtures. The temperature range of the F-T procedure was comprised between -18 ± 2 °C (dry freezing), and 4 ± 2 °C (in water), and the cycles were repeated, on the samples, 10 times. At 0, 1, 5, and 10 cycles, the samples were tested with non-destructive and destructive testing methods, including air voids content, ITSM, ITS, and Cantabro loss. The waters of the thawing period were collected, and the pH, electric conductivity, and particle loss were measured. A consequent change in mechanical behaviour has been recorded between warm and cold produced samples. However, the tests found that the F-T cycles had limited influence on the deterioration of the highly rubberised samples. The loss of particles in the thaw waters were identified as being potentially caused by the temperature stresses. The research suggested various ways to optimise the material to enhance the cold-produced layer mechanical performances, aiming at a fume and smell-free industrialised solution and reducing the potential leaching and particle losses.

Keywords: bitumen emulsion; cold mix; crumb rubber; durability; freeze-thaw; leaching; particle loss; polymer-modified bitumen; rubberised asphalt; warm mix.