Pressure ulcers are mainly caused by prolonged pressure on local tissues. The current method of preventing pressure ulcers is mainly to change the patient's position by turning, so it is significant to study the biomechanics of the typical site of pressure ulcers. Based on anatomical theory, a three-dimensional model of the shoulder and hip was established, and the theoretical contact pressure between the body and the bed was calculated by force analysis. Then, finite element models of typical parts of pressure ulcers were established, and the maximum stresses under different boundary conditions were obtained by finite element analysis. Finally, a human body turning experiment was conducted using a pressure distribution sensor, and the pressure distribution clouds and maximum contact pressure curves under different turning angles were obtained. The results show that the extreme point of maximum stress occurs at [Formula: see text], producing a stress concentration phenomenon; the peak stresses at the shoulder and hip are more balanced in the angular threshold range of [Formula: see text] to [Formula: see text], the stresses are more dispersed, and there exists an angular threshold for optimal integrated pressure, which can improve the efficiency of the use of assisted turning equipment. The relevant results help to explain the causes of pressure ulcer disease and can provide clinical references to improve the effectiveness of care.
Keywords: Biomechanical stimulation; Contact pressure; Pressure ulcers; Rehabilitation technical aids; Turning over.
© 2022. The Author(s) under exclusive licence to Biomedical Engineering Society.