Melt extrusion pretreatment of poly(ethylene terephthalate) (PET) prior to enzymatic depolymerization with an unpurified leaf branch compost cutinase enzyme cocktail is explored to ascertain the efficiency gained by different processing methods on the enzymatic depolymerization of PET. Specific surface area (SSA) is investigated as a key factor in reducing depolymerization time. Higher SSA substrates (>5.6 mm2 mg-1 ) show higher depolymerization rates (≈0.88 g L-1 terephthalic acid [TPA] per day) and no induction phase, while lower SSA substrates (≈4.3, 4.4, and 5.6 mm2 mg-1 ) show, after an initial induction phase, similar depolymerization rates (≈0.46, 0.45, and 0.44 g L-1 TPA per day) despite increases in SSA of up to 30%. The mechanism of enzymatic depolymerization manifests in the appearance of anisotropic pitting. Longer incubation time used to overcome the induction phase in low SSA substrates allows for nearly full recovery of monomeric products, but manual pregrinding of extruded PET sharply increases SSA, depolymerization rate, and substrate crystallinity which may decrease the maximum recycled yield of the product materials. An estimate of the energy cost of increasing SSA is made and its effects on material properties are discussed. This work highlights key material structure and pretreatment aspects influencing the enzymatic recycling of PET.
Keywords: enzymatic depolymerization; plastics; poly(ethylene terephthalate); polymers; processing; tradeoffs.
© 2022 Wiley-VCH GmbH.