Characterization of surface and subsurface defects induced by abrasive machining of optical crystals using grazing incidence X-ray diffraction and molecular dynamics

Yong Zhang; Qi Wang; Chen Li; Yinchuan Piao; Ning Hou; Kuangnan Hu

doi:10.1016/j.jare.2021.05.006

Characterization of surface and subsurface defects induced by abrasive machining of optical crystals using grazing incidence X-ray diffraction and molecular dynamics

J Adv Res. 2021 May 19:36:51-61. doi: 10.1016/j.jare.2021.05.006. eCollection 2022 Feb.

Authors

Yong Zhang¹, Qi Wang¹, Chen Li¹, Yinchuan Piao¹, Ning Hou², Kuangnan Hu¹

Affiliations

¹ School of Mechatronics Engineering, Harbin Institute of Technology, Harbin 150001, China.
² School of Mechatronics Engineering, Shenyang Aerospace University, Shenyang 110136, China.

Abstract

Introduction: Surface and subsurface defects were easily induced during abrasive machining process of optical crystals due to their high brittleness. Accurate characterization of these defects is the prerequisite for obtaining optical components with high surface integrity.

Objectives: This work aims to evaluate subsurface defects of CaF₂ single crystals induced by abrasive machining, the mappings between micro cracks and diffraction pattern curves, and the influence of micro cracks on lattice structures.

Methods: Molecular dynamics simulation, grazing incidence X-ray diffraction experiments and cross-sectional TEM detection were used in this work.

Results: In grazing incidence X-ray diffraction (GIXD) detection experiments on lapping and polished specimens, shifts phenomenon of the peak position under the non-theoretical grazing incidence angle indicated that the subsurface was damaged to a certain extent. The micro cracks of the subsurface were evaluated by the consistent characteristic of "peak drift" of the diffraction pattern curve in both experiments and simulations. In addition, cross-sectional TEM results showed that regular micro cracks were found on the subsurface, which agreed well with the simulation results.

Conclusion: The subsurface defects of CaF₂ single crystals induced by abrasive machining, and the influence of micro cracks on lattice structures can be evaluated by molecular dynamics simulation. The simulation results revealed the mappings between the micro cracks and diffraction pattern curve, which demonstrated that a phenomenon of "peak drift" occurred near the diffraction angle of a specific crystal plane. This work provided a novel technology for the nondestructive testing of defects of single crystal materials at nano- and micro- scales.

Keywords: Abrasive machining; Defect characterization; Grazing incidence X-ray diffraction; Molecular dynamics; Optical crystal; Subsurface damage.