Optimal microcatheter shaping is essential for successful endovascular coiling procedures which is sometimes challenging. Our aim was not only to introduce a new shaping method using three-dimensional (3D) printed vessel models but also to prove its feasibility, efficiency and superiority. This was a retrospective cohort study. From September 2019 to March 2021, 32 paraclinoid aneurysms managed with endovascular coiling were retrospectively included and identified. Sixteen aneurysms were coiled using 3D microcatheter shaping method (3D shaping group), and traditional manual shaping method using shaping mandrels was adopted for another 16 patients (control group). The cost and angiographical and clinical outcomes between the two groups were compared, and the feasibility and effectiveness of the new 3D shaping method were evaluated and described in detail. With technical success achieved in 93.75%, most of the 16 shaped microcatheters using new shaping method could be automatically navigated into the target aneurysms without the assistance of microguidewires and could be assessed with favorable accessibility, positioning and stability. Twenty-seven out of 32 aneurysms (84.38%) were completely occluded with the rate of perioperative complications being 12.50%. Although there was no significant difference between the occlusion rates and complication rates of the two groups, the new shaping method could dramatically decrease the number of coils deployed and reduce the overall procedure time. Patient specific shaping of microcatheters using 3D printing may facilitate easier and safer procedures in coil embolization of intracranial aneurysms with shorter surgery time and less coils deployed.
Keywords: Catheterization; Coil embolization; Intracranial aneurysm; Microcatheter shaping; Three-dimensional printing.
© 2022. The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature.