Converting wood waste into thermoplastic materials is an attractive means of increasing its utilization because complex three-dimensional molded products can easily be obtained by press molding wood with thermoplasticity. Chemical modification, especially esterification, is a promising method for imparting thermoplasticity to wood. In this study, we produced multiple propionylated wood specimens using several propionylation methods and elucidated the factors affecting the deformability of the wood. Regardless of the method, all of the propionylated wood samples showed deformability in the tangential direction. However, in the longitudinal direction, not only the degree of propionylation but also the propionylation method had a significant influence on the deformability. The flow in the tangential direction occurred under a relatively low pressure, whereas the flow in the longitudinal direction occurred under higher pressure. The chemical composition and motility of each sample were evaluated using solid-state NMR measurements. With some propionylation methods, decomposition of the cellulose main chain occurred during the reaction, which had a dominant effect on the deformability of the wood in the longitudinal direction. These results indicate that the deformability of wood can be controlled by the appropriate selection of a propionylation method and its treatment conditions.
Keywords: deformability; esterification; hot-press; mechanism; propionylation; thermoplasticity; wood.