In this investigation, chitosan-coated nickel selenide nano-photocatalyst (CS-NiSe) was successfully prepared through the chemical reduction method. FTIR spectroscopy confirmed the synthesis of CS-NiSe nano-photocatalyst. Further, XRD analysis exhibited a monoclinic crystalline phase of photocatalyst with a crystallite size of 32 nm based on Scherer's equation. The SEM micrographs showed that the photocatalyst has an average particle size of 60 nm. The bandgap of CS-NiSe was (2.85 eV) in the visible region of the spectrum. Due to this reason, the CS-NiSe was applied under solar light illumination for the photocatalytic activity of Erythrosine and Allura red dyes. The CS-NiSe presented the highest degradation efficiency of 99.53% for Erythrosine dye in optimized experimental conditions of 100 min at 30 °C, 30 ppm concentration, pH 5.0, and 0.14 g catalyst dose. For Allura red dye, a high degradation of 96.12% was attained in 120 min at pH 4.0, 100 ppm initial dye concentration, 35 °C temperature, and 0.1 g catalyst dose. The CS-NiSe showed excellent degradation efficiency and reduced to (95% for Erythrosine and 91% for Allura red dye) after five consecutive batches. Moreover, the statistical and neural network modelling analysis showed the significant influence of all studied variables on dyes degradation performance. The results demonstrated that CS-NiSe exhibited excellent photocatalytic performances for Erythrosine and Allura red dyes and could be a better photocatalyst for removing these dyes from industrial effluents.
Keywords: Chitosan; Degradation; Nickel selenide; Organic pollutants; Photocatalyst; Reusability.
Copyright © 2021 Elsevier B.V. All rights reserved.