This study investigated the heat treatment response and tensile properties of Al-6 mass%Mg-xSi (x = 1, 3, 5, and 7 mass%) ternary alloys. Further, the fracture behavior of these alloys in response to heat treatment for different temper conditions was also examined. Scanning electron microscopy-energy dispersive X-ray spectrometry (SEM-EDS) analysis of the as-cast alloys revealed, in all of them, the presence of iron-bearing phases (in a size range of 10˜60 μm) that did not dissolve or become refined upon heat treatment. Additionally, eutectic Mg₂Si and Al₃Mg₂ phases were found in Alloy I (Al-6Mg-1Si), while eutectic Mg₂Si and Si phases were found in the rest of the alloys. In the as-cast condition, the tensile properties of the examined alloys decreased in relation to increasing Si content. Nonetheless, after heat treatment, the yield strength of the alloys with high Si content (>3 mass%) increased significantly compared with that in the as-cast condition. A yield strength greater than 300 MPa was achieved in both Alloy III (Al-6Mg-5Si) and Alloy IV (Al-6Mg-7Si), although this was achieved at the expense of ductility. According to the fractography of the tensile-fractured surfaces undertaken using optical and scanning electron microscopy, fractures of the iron-bearing phases were found to be the source of cracking in alloys with high Si content. In the case of those with low Si content (≤3 mass%), cracks were believed to have been caused by the debonding of iron-bearing phases from the aluminum matrix.