In this study, a photo-catalyst of titanium oxide was coated on zeolite by the sol-gel method. The generation of the zeolite-titanate photo-catalyst was optimized at conditions of calcination temperature (300, 350, 400 and 500 °C), calcination time (1, 2, 3, and 4 h), and titanate content (0, 2, 4, 6, and 8 mL). The catalyst was used for 'Sonication/UV/H2O2″ activity and finally, eliminating ibuprofen. Physicochemical properties of the as-built photo-catalysts for all optimized conditions were determined using FESEM-EDX-mapping, BET, FTIR, and XRD. The highest percentage of ibuprofen removal (98.9%) was obtained at conditions of zeolite to titanium ratio of 1 g: 2 mL, time in the furnace of 1 h, and temperature of the furnace of 350 °C. The optimum photo-catalytic (namely, Cat-350-1-2) had a surface area value of 39 m2/g and a crystalline size of 4.9 nm. The surface area for all photo-catalysts increased after being used for ibuprofen removal, possibly due to ultrasonic waves. The presence of Ti-O, benzene ring, O-Al-O, O-Si-O, C-H, and O-H in the photo-catalysts structure were confirmed. Growing the calcination time resulted in an increase in the crystallinity of titanium dioxide in the photo-catalysts and, ultimately a reduction in the ibuprofen removal. The consumed energy by the developed system was calculated for the presence (0.094 kJ/g) and absence (17.5 kJ/g) of the ultrasonic wave. The degradation pathway and reaction kinetic are also explored and proposed. The results showed that the ultrasonic-UV-activated H2O2-based technique can be applied as an alternative method for ibuprofen removal from aqueous media.
Keywords: Ibuprofen; Photo-catalyst; Titanium dioxide; Ultrasonic wave; Zeolite.
Copyright © 2020 Elsevier B.V. All rights reserved.