Machinability of high-speed enamel cutting with carbide bur

Abstract

The cutting of tooth enamel using a high-speed air-turbine handpiece and carbide bur is a key procedure in oral surgeries, such as the minimally invasive extraction. However, presently little is known about the cutting mechanics and material removal mechanism related to tooth enamel machinability. In this study, the machinability of high-speed enamel cutting with carbide bur is studied by a computer-aided numerical control system. The dynamic cutting forces of enamel of the occlusal, buccal/lingual, and proximal surfaces were measured by the force measuring system. The force ratio, cutting torque, rotating speed, specific cutting energy, and bur wear were analyzed. The microstructure of enamel and carbide burs was observed by the scanning electron microscope, and the relationship between enamel microstructures and machinability was further analyzed. The results show that during the high-speed enamel cutting with carbide bur, the chip thickness is on the nano-scale, and the plastic deformation of the machined surface is obvious. With increased material removal rate, the cutting force, torque, specific cutting energy, and bur wear increases accordingly, whereas the rotating speed decelerates (p < 0.05). The different angles between the cutting direction and the axial direction of the enamel rods give rise to the large differences in the cutting mechanics and mechanism of the proximal, buccal/lingual, and occlusal surfaces of the teeth. When the cutting direction is parallel, vertical, and oblique 45° to the axial direction of the enamel rods, the force required for material fracture and crack propagation increases, and the cutting force increases as a consequence. Parallel and oblique 45° cutting are the main modes of tooth segmentation in the minimally invasive extraction. In comparison with the parallel cutting mode, the cutting force, torque, and cutting ratio of the oblique 45° cutting mode can be significantly increased, and the tool wear is obviously accelerated. This is the lowest priority in segmentation surgery, hence the problems of overload and temperature rise need to be considered. The cutting mechanics and cutting mechanism obtained in this study will provide scientific process guidance for dental cutting operations with the air-turbine handpiece driving bur.

Keywords: Cutting force; Enamel; Fracture; Machinability; Material removal mechanism.