The objective of this study was to examine the effects of extrinsic or intrinsic acids on nanofilled and bulk fill resin materials in vitro. A total of 90 disks were prepared using dental restorative material (Filtek Z350XT, GrandioSO, Filtek Bulk Fill, X-tra fil). Thirty disks of each material were sub-divided into three groups (n = 10) that were immersed for 7 days in deionized water (DW), 5% citric acid (CA-pH 2.1), or 0.1% hydrochloric acid (HCl-pH = 1.2). Surface hardness and roughness (stylus profilometer by Ra parameter) analysis were performed before and after immersion. Morphological changes were evaluated by scanning electron microscopy. The data were analyzed by two-way ANOVA and Tukey's test (α = 0.05). All tested materials did not show significant differences in the effects of the DW, CA, or HCl solutions on surface roughness (p = .368). Likewise, the hardness loss was not affected by the solutions tested (p = .646), but there was a difference in the resin type (p = .002). Filtek Bulk Fill resin hardness was less affected, while Filtek Z350XT and GrandioSO presented the most hardness loss after 7 days of solution immersion. In terms of this experimental study, the results demonstrate the effectiveness of the mechanical properties (roughness and hardness surface) of nanofilled and bulk fill resin materials to resist erosion from extrinsic and intrinsic acids, therefore being potential candidates for dental applications.
Keywords: citric acid; esthetic restorative material; hydrochloric acid; microhardness; surface roughness.
© 2019 Wiley Periodicals, Inc.