Thin films of CH3NH3PbI3 and (NH2)2CHPbI3 (from now on abbreviated as MAPI and FAPI respectively), with perovskite structure were prepared by sequential evaporation of lead iodide (PbI2) and methylammonium iodide (MAI) or formamidinium iodide (FAI), with special emphasis on the optimization of its optical, morphologic, and structural properties. For this, the evaporation process was automatically controlled with a system developed using virtual instrumentation (VI) that allows electronic control of both evaporation sources temperature and precursors deposition rates, using proportional integral derivative (PID) and pulse width modulation (PWM) control algorithms developed with the LabView software. Using X-ray diffraction (XRD), information was obtained regarding the phase and crystalline structure of the studied samples as well as the effect of the main deposition parameters on crystallite size and microstrain. We also studied the influence of the main deposition parameters on the optical and morphological properties through measurements of spectral transmittance and scanning electron microscopy (SEM) respectively. It was found that the implemented method of sequential evaporation allows preparing, with a high degree of reproducibility, single phase MAPI and FAPI thin films with appropriate properties to be used as active layer in hybrid solar cells. The applicability of MAPI and FAPI thin films as active layer in photovoltaic devices has been demonstrated by using them in solar cells with structure: FTO/ZnO/MAPI(or FAPI)/P3HT/Au.
Keywords: FAPI; MAPI; Perovskite thin films; microstructure; planar perovskite solar cells.