Beam-induced oxidation of mixed-valent Fe (oxyhydr)oxides (green rust) monitored by STEM-EELS

H M Freeman; J P H Perez; N Hondow; L G Benning; A P Brown

doi:10.1016/j.micron.2019.02.002

Beam-induced oxidation of mixed-valent Fe (oxyhydr)oxides (green rust) monitored by STEM-EELS

Micron. 2019 Jul:122:46-52. doi: 10.1016/j.micron.2019.02.002. Epub 2019 Feb 10.

Authors

H M Freeman¹, J P H Perez², N Hondow³, L G Benning⁴, A P Brown³

Affiliations

¹ GFZ German Research Center for Geosciences, Telegrafenberg, 14473, Potsdam, Germany; School of Chemical and Process Engineering, University of Leeds, Leeds, LS2 9JT, United Kingdom. Electronic address: h.m.freeman@leeds.ac.uk.
² GFZ German Research Center for Geosciences, Telegrafenberg, 14473, Potsdam, Germany; Department of Earth Sciences, Free University of Berlin, 12249, Berlin, Germany.
³ School of Chemical and Process Engineering, University of Leeds, Leeds, LS2 9JT, United Kingdom.
⁴ GFZ German Research Center for Geosciences, Telegrafenberg, 14473, Potsdam, Germany; Department of Earth Sciences, Free University of Berlin, 12249, Berlin, Germany; School of Earth and Environment, University of Leeds, Leeds, LS2 9JT, United Kingdom.

PMID: 30979573
DOI: 10.1016/j.micron.2019.02.002

Abstract

Analytical transmission electron microscopy (TEM) is often used to investigate morphologies, crystal structures, chemical compositions and oxidation states of highly reactive mixed-valent mineral phases. Of prime interest, due to its potential role in toxic metal remediation, is green rust sulphate (GR_SO4) an Fe^II-Fe^III layered double hydroxide. In this study, we quantified the effects that TEM analysis has on GR_SO4 in order to ensure the measured material properties are a result of synthesis and reaction kinetics, and not due to sample preparation and analysis technique. To do this, we compared two sample preparation techniques (anoxic drop-cast with drying, and frozen-hydrated cryogenic) and exposed samples to the electron beam for several minutes, acquiring fluence series between ca. 40 e^- Å^-2 and 10,000 e^- Å^-2. TEM imaging and electron diffraction showed that the hexagonal plate-like morphology and crystal structure of GR_SO4 were largely unaffected by sample preparation and analysis technique. However, quantitative analysis of a series of monochromated Fe L_3,2-edge electron energy loss spectra (EELS) showed that electron irradiation induces oxidation. We measured an Fe(II)/Fe(III) ratio of 1.94 (as expected for GR_SO4) at 50 e^- Å^-2. However, above this fluence, the ratio logarithmically decreased and dropped to ca. 0.5 after 1000 e^- Å^-2. This trend was approximately the same for both sample preparation techniques implying that it is the beam alone which causes valence state changes, and not exposure to oxygen during transfer into the TEM or the vacuum of the TEM column. Ultimately this work demonstrates that GR valence can be quantified by EELS provided that the sample is not over exposed to electrons. This also opens the possibility of quantifying the effect of redox-sensitive toxic metals (e.g., As, Cr, Se) on Fe oxidation state in GR phases (relevant to the treatment of contaminated soils and water) with a higher spatial resolution than other techniques (e.g., Mössbauer spectroscopy).

Keywords: Cryo-TEM; Fe oxidation; Green rust; Low dose TEM; Monochromated EELS.

Publication types

Research Support, Non-U.S. Gov't