Numerical data on the shear stress distribution generated by a rotating rod within a stationary ring over a 35-mm cell culture dish

Nuttapol Limjeerajarus; Boonrit Keawprachum; Maytus Pliankum; Prasit Pavasant; Chalida Nakalekha Limjeerajarus

doi:10.1016/j.dib.2018.11.087

Numerical data on the shear stress distribution generated by a rotating rod within a stationary ring over a 35-mm cell culture dish

Data Brief. 2018 Nov 22:21:2253-2258. doi: 10.1016/j.dib.2018.11.087. eCollection 2018 Dec.

Authors

Nuttapol Limjeerajarus¹, Boonrit Keawprachum¹, Maytus Pliankum¹, Prasit Pavasant², Chalida Nakalekha Limjeerajarus^{3

4}

Affiliations

¹ Research Center for Advanced Energy Technology, Faculty of Engineering, Thai-Nichi Institute of Technology, Bangkok 10250, Thailand.
² Department of Anatomy, Faculty of Dentistry, Chulalongkorn University, Bangkok 10330, Thailand.
³ Department of Physiology, Faculty of Dentistry, Chulalongkorn University, Bangkok 10330, Thailand.
⁴ Excellence Center in Regenerative Dentistry, Faculty of Dentistry, Chulalongkorn University, Bangkok, Thailand.

Abstract

The data contained within this article relate to a rotating rod within a stationary ring that was used to generate shear stress on cells and tissues via a medium. The geometry of the rotating rod within a stationary ring was designed to work with a 35-mm diameter culture dish. The data of the shear stress distribution are presented in terms of area-weighted average shear stress and the uniformity index, which were calculated for medium volumes of 4 and 5 ml at various rotational speeds ranging from 0 to 1000 rpm.