The aim of this study was to compare conventional and digital additive manufacturing of hard occlusal stabilization splints (SS) using technical and clinical parameters. 14 subjects were subjected to DC/TMD Axis I clinical examination protocol and Axis II questionnaire. The subjects underwent treatment with splints over a period of 12 weeks. All subjects underwent both conventional alginate impression and intraoral digital scanning. Seven subjects received conventional manufactured stabilization splints (CM-SS), and seven subjects received CAD-CAM additive manufactured stabilization splints (AM-SS). 12 subjects completed the 12 weeks follow-up period. The subjects significantly preferred digital intraoral scanning compared to conventional alginate impression. There was a significant difference in VAS between CM-SS and AM-SS. The mean VAS result was 15 for AM-SS and 42 for CM-SS, 0 represented excellent comfort and 100 very uncomfortable. This was significant. Splint manufacturing method had no influence on treatment outcome. There was no significant difference in mean delta change for unassisted jaw opening from baseline to 12 weeks between the two groups, for CM-SS it was 2 mm difference and for AM-SS the difference was 3 mm. All subjects in both treatment groups showed improved oral function. In this study, the scanning procedure is more accepted by the subjects than alginate impressions, however the first procedure was more time consuming.
Keywords: CAD-CAM; Digital impression; hard occlusal stabilization splint.