A New Design of In Situ Ti(C,N) Reinforced Composite Coatings and Their Microstructures, Interfaces, and Wear Resistances

Mingliang Wang; Hongzhi Cui; Na Wei; Lei Ding; Xinjie Zhang; Yong Zhao; Canming Wang; Qiang Song

doi:10.1021/acsami.7b17286

A New Design of In Situ Ti(C,N) Reinforced Composite Coatings and Their Microstructures, Interfaces, and Wear Resistances

ACS Appl Mater Interfaces. 2018 Jan 31;10(4):4250-4265. doi: 10.1021/acsami.7b17286. Epub 2018 Jan 17.

Authors

Mingliang Wang¹, Hongzhi Cui¹, Na Wei¹, Lei Ding¹, Xinjie Zhang¹, Yong Zhao¹, Canming Wang¹, Qiang Song¹

Affiliation

¹ School of Materials Science and Engineering, Shandong University of Science and Technology , Qingdao 266590, China.

PMID: 29293310
DOI: 10.1021/acsami.7b17286

Abstract

Here, a unique combination of a novel carbon-nitrogen source (g-C₃N₄) with different mole ratios of Ti/g-C₃N₄ has been utilized to fabricate iron matrix composite coatings by a synchronized powder feeding plasma transferred arc (PTA) cladding technology. The results show that submicron Ti(C,N) particles are successfully fabricated in situ on a Q235 low carbon steel substrate to reinforce the iron matrix composite coatings and exhibit dense microstructures and good metallurgical bonding between the coating and the substrate. The microstructure of the coating consists of an α-Fe matrix and Ti(C,N) particles when the mole ratio of Ti/g-C₃N₄ is no more than 5:1. The microhardness and wear resistance of the coating gradually improve with increasing abundance of the in-situ-synthesized Ti(C,N) particles. Interestingly, for a Ti/g-C₃N₄ mole ratio of 6:1, a fine lamellar eutectic Laves phase (Fe₂Ti) appears, and this phase further improves the microhardness and wear resistance of the coating. The microhardness of the coating is 3.5 times greater than that of the Q235 substrate, and the wear resistance is enhanced 7.66 times over that of the substrate. The Ti(C,N)/Fe₂Ti and Fe₂Ti/α-Fe interfaces are very clean, and the crystallographic orientation relationships between the phases are analyzed by high-resolution transmission electron microscopy (HRTEM) and an edge-to-edge matching model. The theoretical predictions and the experimental results are in good agreement. Furthermore, based on the present study, for the solidification process near equilibrium, smaller interatomic spacing misfits and interplanar spacing d-value mismatches contribute to the formation of crystallographic orientation relationships between phases during the PTA cladding process. The existence of orientation relationships is beneficial for improving the properties of the coatings. This work not only expands the application fields of g-C₃N₄ but also provides a new idea for the preparation of Ti(C,N) particle-reinforced composite coatings.

Keywords: PTA cladding coating; Ti(C,N) particles; crystallographic orientation relationships; g-C3N4; interface; lamellar eutectic Fe2Ti; wear resistance.