Particulate matter (PM) from cooking has caused seriously indoor air pollutant and aroused risk to human health. It is urged to get deep knowledge of their spatial-temporal distribution of source emission characteristics, especially ultrafine particles (UFP<100nm) and accumulation mode particles (AMP 100-665nm). Four commercial cooking oils are auto dipped water to simulate cooking fume under heating to 265°C to investigate PM emission and decay features between 0.03 and 10μm size dimension by electrical low pressure impactor (ELPI) without ventilation. Rapeseed and sunflower produced high PM2.5 around 6.1mg/m3, in comparison with those of soybean and corn (5.87 and 4.65mg/m3, respectively) at peak emission time between 340 and 460sec since heating oil, but with the same level of particle numbers 6-9×105/cm3. Mean values of PM1.0/PM2.5 and PM2.5/PM10 at peak emission time are around 0.51-0.66 and 0.23-0.29. After 15min naturally deposition, decay rates of PM1.0, PM2.5 and PM10 are 13.3%-29.8%, 20.1%-33.9% and 41.2%-54.7%, which manifest that PM1.0 is quite hard to decay than larger particles, PM2.5 and PM10. The majority of the particle emission locates at 43nm with the largest decay rate at 75%, and shifts to a larger size between 137 and 655nm after 15min decay. The decay rates of the particles are sensitive to the oil type.
Keywords: Cooking fume; Emission character; Number concentration; Size distribution; Ultrafine particle.
Copyright © 2016. Published by Elsevier B.V.