Stress measurements of planar dielectric elastomer actuators

Rev Sci Instrum. 2016 May;87(5):053901. doi: 10.1063/1.4949519.

Abstract

Dielectric elastomer actuator (DEA) micro- and nano-structures are referred to artificial muscles because of their specific continuous power and adequate time response. The bending measurement of an asymmetric, planar DEA is described. The asymmetric cantilevers consist of 1 or 5 μm-thin DEAs deposited on polyethylene naphthalate (PEN) substrates 16, 25, 38, or 50 μm thick. The application of a voltage to the DEA electrodes generates an electrostatic pressure in the sandwiched silicone elastomer layer, which causes the underlying PEN substrate to bend. Optical beam deflection enables the detection of the bending angle vs. applied voltage. Bending radii as large as 850 m were reproducibly detected. DEA tests with electric fields of up to 80 V/μm showed limitations in electrode's conductivity and structure failures. The actuation measurement is essential for the quantitative characterization of nanometer-thin, low-voltage, single- and multi-layer DEAs, as foreseen for artificial sphincters to efficiently treat severe urinary and fecal incontinence.

Publication types

  • Research Support, Non-U.S. Gov't

MeSH terms

  • Elastomers*
  • Electric Impedance
  • Electrodes
  • Membranes, Artificial
  • Pressure
  • Stress, Mechanical*

Substances

  • Elastomers
  • Membranes, Artificial