Methylcyclopentadienyl manganese tricarbonyl (MMT) is a fuel additive that has been marketed for use in unleaded gasoline since December 1995. The widespread use of this additive has been suggested to cause health risks, but limitations in data regarding its degradation products and their toxicity prevent an accurate evaluation. To monitor the organomanganese compounds, it is clearly advantageous to employ low-cost, high-sensitivity, manganese-specific instrumentation to perform speciation. In this work, instrumentation fitting these criteria was obtained by the combination of high-performance liquid chromatography (HPLC) with diode laser atomic absorption spectrometry (DLAAS) and was used to determine MMT, its nonmethylated derivative, cyclopentadienyl manganese tricarbonyl (CMT), and inorganic manganese. DLAAS was shown to be a versatile analytical technique for total Mn determination, with a detection limit of 1 ng/mL and a linear dynamic range (LDR) of almost 5 orders of magnitude. Analytical figures of merit for HPLC-DLAAS included a detection limit of 2 ng(as Mn)/mL, a LDR of 3 orders of magnitude, and an analysis time of three minutes. The organometallic compounds are characterized by rapid photolysis in sunlight, and hence, experiments were performed to evaluate whether normal laboratory lighting is suitable for their determination. Our results showed that normal laboratory protocols may be employed except that the organomanganese compounds should be stored away from light except during sample introduction procedures. The ability of the instrumentation to selectively preconcentrate organomanganese compounds while removing inorganic manganese was demonstrated. Sufficient resolution was obtained to determine a 20-fold excess of CMT compared with MMT. The ability of the system to do practical analysis was demonstrated by the accurate determination of MMT in spiked samples of gasoline, human urine, and tap water. These results demonstrate the suitability of HPLC-DLAAS for the speciation of MMT and its derivatives in industrial, toxicological, and environmental samples.