The helix-coil transition of poly[d(I-C)] and poly[d(A-T)] was studied as a function of hydrostatic pressure, temperature, and sodium ion concentration. These studies were undertaken in light of a recently published phase diagram for double stranded nucleic acids [Dubins et al. J. Am. Chem. Soc. 2001, 123, 9254-9259]. The sign and magnitude of the volume change for the heat-induced helix-coil transition, DeltaV(T), of poly[d(I-C)] and poly[d(A-T)] were dependent on the helix-coil transition temperature, T(M), at atmospheric pressure. The sign of DeltaV(T) changed from negative to positive as T(M) was increased by increasing the sodium ion concentration. For poly[d(I-C)], DeltaV(T) = 0 cm(3) mol(-1), when the sodium ion concentration is such that the spectroscopically monitored T(M) = 55 degrees C at atmospheric pressure. For poly[d(A-T)], the value of DeltaV(T) = 0 under conditions such that T(M) = 47 degrees C at atmospheric pressure. Negative values of DeltaV(T) imply that the helical form is destabilized at high pressure. Under experimental conditions where the DeltaV(T) for the transition is negative, the transition could be caused by increasing the pressure under isothermal conditions. At temperatures below T(M) measured at atmospheric pressure the midpoint of the pressure-induced helix-coil transition, P(M), decreases with increasing temperature. The volume change of the pressure-induced transitions helix-coil transition, DeltaV(P), was calculated assuming a two-state model. The magnitude of DeltaV(P) (per cooperative length) was much larger than the volume change (per base pair) measured for the heat-induced transition, DeltaV(T), calculated using the Clapeyron equation. The ratio of these two volume changes was used to calculate the cooperative length for the pressure-induced transition. This parameter depends strongly on temperature, becoming greater closer to T(M) measured at atmospheric pressure. At temperatures approaching T(M) the magnitude of the cooperative length of the pressure-induced transition is approximately twice that observed for the heat-induced transition (N(T)). On the basis of the temperature dependence of the DeltaV(T) for the two polymers the coefficient of thermal expansion of the two polymers was found to be 0.17 and 0.16 cm(3) K(-1) mol(-1) for poly[d(I-C)] and poly[d(A-T)], respectively.