The trace metal contents in fruiting bodies of ectomycorrhizal (ECM) fungi, symbiotic partners of Scots pine, were studied on three sites situated in west-central Poland. Elements were determined by atomic absorption spectrometry in 123 samples of 16 species. The study explored the differences in metal accumulation in relation to site, fungal species, age and part of the fruiting body and results were related to metal content in soil and plant material (roots and needles). Soil analysis revealed that results were obtained under environmental conditions not subject to strong anthropogenic pressure. Median metal concentrations did not differ disparately between sites, although the concentrations of each of the tested metals in the individual species varied to a large extent. Extremely high levels of Al with a large bioconcentration factor (BCF) were found in sporocarps of Thelephora terrestris. The spread between the highest and the lowest concentration (max/min) was very wide in Al, Cd and Pb and these elements may be considered to be absorbed preferentially by fruiting bodies of some species whereas Fe, Mn and Zn, with relatively low values of max/min, are normally absorbed by the majority of fungi. There was no clear relationship between caps and stipes in metal content. However, a tendency to higher metal concentration in the caps was observed. The metal content in young and older fruiting bodies of five different fungi was species dependent. In order to estimate the degree of accumulation of each element by plant and mushrooms, bioconcentration factors (BCFs) were calculated. In plant material (roots and needles), highest values of BCFs were noted for essential metals, like Zn and Mn. Lead showed a definite exclusion pattern (BCF below 1). In fruiting bodies of tested fungi, especially in Amanita muscaria, cadmium was the most intensively accumulated metal. Lead was excluded by plants but was accumulated or excluded by fungi depending on the species. The significance of mycological observation and quantification of the metal content in monitoring of the forest ecosystem is discussed.