Adsorption of Cd(II) species at pH = 5 was studied on three carbon adsorbents: granular activated carbon, activated carbon fiber, and activated carbon cloth. As-received and oxidized adsorbents were used. Cd(II) adsorption greatly increased after oxidation due to the introduction of carboxyl groups. The use of a buffer solution to control the pH introduced some changes in the surface chemistry of carbons through the adsorption of one of the compounds used, biphthalate anions. The increase in ionic strength reduced Cd(II) uptake on both as-received and oxidized carbons due to a screening of the electrostatic attractions between the Cd(II) positive species and the negative surface charge, which in the case of as-received carbons derived from the biphthalate anions adsorbed and in the oxidized ones from the carboxyl groups. Tannic acid was used as a model compound for natural organic matter. Its adsorption was greatly reduced after oxidation, and most of the carbon adsorbents preadsorbed with tannic acid showed an increase in Cd(II) uptake. In the case of competitive adsorption between Cd(II) species and tannic acid molecules, there was a decrease in Cd(II) uptake on the as-received carbon whereas the contrary occurred with the oxidized carbons. These results illustrate the great importance of carbon surface chemistry in this competitive adsorption process. Finally, under all experimental conditions used, when the adsorption capacity of carbons was compared under the same conditions it increased in the following order: granular activated carbon < activated carbon fiber < activated carbon cloth.