To achieve sustainable range management and avoid or minimize environmental contamination, the Army needs to know the amount of explosives deposited on ranges from different munitions and how these are degraded and transported under different geological and climatic conditions. The physical form of the deposited explosives has a bearing on this problem, yet the shapes and size distributions of the explosive particles remaining after detonations are not known. We collected residues from 8 high-order and 6 low-order non-tactical detonations of TNT-filled 155-mm rounds. We found significant variation in the amount of TNT scattered from the high-order detonations, ranging from 0.00001 to 2% of the TNT in the original shell. All low-order detonations scattered percent-level amounts of TNT. We imaged thousands of TNT particles and determined the size, mass and surface-area distributions of particles collected from one high-order and one low-order detonation. For the high-order detonation, particles smaller than 1 mm contribute most of the mass and surface area of the TNT scattered. For the low-order detonation, most of the scattered TNT mass was in the form of un-heated, centimeter-sized pieces whereas most of the surface area was again from particles smaller than 1 mm. We also observed that the large pieces of TNT disintegrate readily, giving rise to many smaller particles that can quickly dissolve. We suggest picking up the large pieces of TNT before they disintegrate to become point sources of contamination.